Just camsex - Strickly america dating sites

All three run great and we alternate with them mowing 6.5 acres...the midst of downsizing so need to sell them all. Any information on this tractor would be really helpful. motor and use it to move snow and maintain my driveway it would be nice to have a repair manual and i would like to try and find the sheet metal to make it look original any imfo.

Peninsula, Oh I recenly purchased a 1961 761 speed-o-matic Ford tractor. would help thank a m-f 65 diesel sndw703411 ser#;engine #2974698 four wheels can be used for two rowe but i use mostley one rowe, bush hog and some time harrow very good on diesel tires are good body is good needs new paint think has original would like to fix it up to show but am 84 it run very good had it about 15 years make me offer waycross ga 31503 806 waring st.

I would appreciate any information anyone might have.

strickly  america dating sites-12strickly  america dating sites-57strickly  america dating sites-56

Strickly america dating sites

Do avoid any bends at the base end of the guide tube as your repair isnt flexable. Ohio and my father and I rebuilt the First Farmall Regular sold there. We restored it in the early 60s and my Dad sold it in the early 90s but I don t know who. My brother Ron, Dad and I had a lot of good times in on the rebuild.

I have a 4040 Industrial with sos trans - I found screen filter at bottom of trans does anyone know where another filter might be hiding Trans doesnt work in higher ranges and reverse until really warmed up - any Ideas I have a 4040 Industrial with sos trans - I found screen filter at bottom of trans does anyone know where another filter might be hiding Trans doesnt work in higher ranges and reverse until really warmed up - any Ideas I have a 54 Fordson Major Deisel i am fully restoring to original condition new clutch, pressure plate, stripped down new paint, pump and injectors rebuilt.

i ialso installed a ignition coil an im pretty sure that b4 i removede the old one the positive terminal went to the points but just need verification of that any help would be nice i cant seem to get fire to the points.

thanks Hello, I was wondering if anyone had the Center member and the Front support, and/or a backhoe for a 1955 Fordson Major Diesel that they would like to sell If you do please call me at 208 587-7647. I have a early 60 s model Ford 2000 Super Dexta for sale.

My husband passed away so I don t know anything about it It hasn t been started in years. if they use the wrong settings it will smoke bad enough to kill all the mosquitoes for miles. Started driving a Model L when I was 11 years old, pulling a Baldwin Combine that my Dad was operating.

I live in Montana so if anyone is interested you can call 406-679-7907Any injection pump shop should be able to rebuild your pump. both the 56 and the 58 should be the larger 8 mm pump. We then moved to eastern CO and I started plowing sod on a 2 section farm driving the same Model L. Skelton, was the first Case dealer in Hereford, TX.i have installed points on my neighbors ford 8n its the new style bc the distributor is a side mount.

If you could get back to me with some info thank you ! I don t know what year and I don t know where to find the serial #. I live in eastern North Carolina and I don t know where to find parts for the hydraulics. I like a few have found this cable hard to find at best. well burn off both ends with a torch careful not to burn off cable.

I went to a tractor store for an O ring the guys there said they had never heard of a Ford Super Major backhoe but they assured me that the O ring I got would seal. fit both ends in a vice and begin to braze with very low heat I mean real low dont rush work brass into 3/8 inch of the cable on both sides of junction. after you have admired your worst braze job get your file a beverage and some working music.

Does anyone know of any power steering that will adapt to a dexta like a set up from a 3000 or 4000 ford. We havwe owned a 1954 Deisel Fordson Major for 15 years it is 50 hp. We ar now replacing the hread gasket and we dont know what the tourque pressure per pound is for the head bolts.

Dont want give up my tractor for anything I recently got a 801 with sos, the tractor has a short delay when shifted into gear before it will move.

Both of the new tractors had a different feel, like driving a Ford tractor.

Tags: , ,